FixVault
Home › Pontiac › 2002 › Aztek AWD › Repair and Diagnosis › External Pages › Different car › Section 1616 (Engine Controls And Fuel - 2.4L - Introduction) › Repair Instructions › Crankshaft Position Sensor Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the starter motor. Refer to Starter Replacement (LZ4) or Starter Replacement (LE5/LAT) or Starter Replacement (LY7) .
    2. Fig 1: View Of Starter And Engine Electrical Connectors
    GM1809558Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the engine wiring harness electrical connector (1) from the crankshaft position (CKP) sensor.
    3. Fig 2: Identifying CKP Sensor
    GM1578475Courtesy of GENERAL MOTORS CORP.
  3. Remove the CKP sensor bolt.
  4. Remove the CKP sensor.
About FixVault