FixVault
Home › Pontiac › 2002 › Aztek AWD › Repair and Diagnosis › External Pages › Different car › Section 1616 (Engine Controls And Fuel - 2.4L - Introduction) › Repair Instructions › Fuel Pressure Sensor Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Fuel Pressure Sensor
    GM1885087Courtesy of GENERAL MOTORS CORP.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Disconnect the body wiring harness electrical connector (1) from the fuel pressure sensor (2).
    3. Fig 2: Fuel Pressure Sensor
    GM1885089Courtesy of GENERAL MOTORS CORP.
  3. Wrap a shop towel around the fuel pressure sensor fitting in order to absorb any fuel that may leak out.
  4. Remove the fuel pressure sensor (1) from the fuel line.
  5. Remove and discard the fuel pressure sensor O-ring seal (2).
About FixVault