FixVault
Home › Pontiac › 2002 › Aztek AWD › Repair and Diagnosis › External Pages › Different car › Section 1617 (Engine Controls And Fuel - 3.5L - Introduction) › Repair Instructions › Crankshaft Position Sensor Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Engine Wiring Harness Heat Shield Bolts
    GM1887297Courtesy of GENERAL MOTORS CORP.
  1. Remove the right catalytic converter. Refer to Catalytic Converter Replacement - Right Side (LZ4) .
  2. Remove the engine wiring harness heat shield nut (3).
  3. Remove the engine wiring harness heat shield bolts (1 and 4).
  4. Remove the engine wiring harness heat shield (2).
    5. Fig 2: Knock Sensor & Crankshaft Position Sensor & Connectors
    GM1887298Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the engine wiring harness electrical connector (4) from the crankshaft position (CKP) sensor (3).
    6. Fig 3: View Of CKP Sensor
    GM1587763Courtesy of GENERAL MOTORS CORP.
  6. Remove the CKP sensor stud.
  7. Remove the CKP sensor.
About FixVault