PID/Data Monitor & Record
WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
- PID/Data Monitor and Record option allows technician using scan tool to read the state of several Parameter IDs (PIDs) to aid in diagnosing the system.
- Connect scan tool to Data Link Connector (DLC), located under instrument panel to right of steering column. Turn ignition switch to RUN position. Follow manufacturer"s instructions for scan tool being used. PIDs are continuously updated on scan tool display. See PARAMETER IDENTIFICATION (PID) INDEX & VALUES table.
PARAMETER IDENTIFICATION (PID) INDEX & VALUES
| PID/Description | Unit/Condition | Condition/Specification |
|---|---|---|
| CCNT-RCM (Number of continuous DTCs) |
|
|
| CRSH-RC (Number of collisions detected) |
|
|
| D-ABAGR (Driver-side air bag module inflator No. 1 resistance; D-ABAGR2 (Driver-side air bag module inflator No. 2 resistance | Ohm | Under any condition: 1.5-3.7 ohms |
| DR-BUKL (Driver-side buckle switch state); PS-BUKL (Passenger-side buckle switch state) | Buckled/Unbuckled |
|
| DFCURTNRES (Driver-side curtain air bag module resistance); PFCURTNRES (Passenger-side curtain air bag module resistance) | Ohm | Under any condition: 1.4-3.2 ohms |
| DR-PTENS (Driver-side pretensioner resistance); PS-PTENS (Passenger-side pretensioner resistance) | Ohm | Under any condition: 1.5-3.1 ohms |
| DS-AB (Left-side air bag module resistance); PS-AB (Right-side air bag module resistance) | Ohm | Under any condition: 1.4-3.2 ohms |
| OCS-CAL-ST (Seat weight sensor calibration status) |
|
|
| OCS-DTC-ST (Seat weight sensor status) |
|
Fault information cleared at seat weight sensor |
| OCS-FLT (Passenger sensing system status) |
|
|
| OCS-ST (Seat weight sensor status) |
|
Occupant classification status determined by seat weight sensor status |
| PS-Weight (Seat weight sensor measure weight of passenger) | KG | Display of load (body weight) on passenger-side seat |
| P-ABAGR (Passenger-side air bag module inflator No. 1 resistance; P-ABAGR2 (Passenger-side air bag module inflator No. 2 resistance | Ohm | Under any condition: 1.4-2.9 ohms |
| VBATTRCM (SAS control module input voltage) | Volt |
|
| TRAK-SW |
|
|
DIAGNOSTIC SYMPTOMS
| Condition | Go To Test |
|---|---|
| AIR BAG warning light does not illuminate | TEST A: AIR BAG WARNING LIGHT DOES NOT ILLUMINATE |
| AIR BAG warning light on continuously | TEST B: AIR BAG WARNING LIGHT ON CONTINUOUSLY |
FAULT CODE IDENTIFICATION