Passenger Junction Box (PJB) Configuration

WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.

Connect the WDS or equivalent to the DLC-2 (16-pin).
Set up the WDS or equivalent (including the vehicle recognition).
Select "Module Programming".

Fig 1: Locating Data Link Connector
Courtesy of MAZDA MOTORS CORP.
Select "Programmable Module Installation".
Select "GEM" and perform procedures according to directions on the WDS or equivalent screen.
Select "Module Programming".
Select "Programmable Parameters".
Select "Module Reset".
Select "GEM" and perform procedures according to directions on the WDS or equivalent screen.
Retrieve DTCs using the WDS or equivalent and verify that there is no DTC present.
- If any DTC is present, perform applicable DTC inspection. (See DTC TABLE [PJB] .)