Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Install the fog lamp assembly (1) to the bracket.
CAUTION:
Halogen bulbs contain gas under pressure. Handling a bulb improperly could cause it to shatter into flying glass fragments. To help avoid personal injury:

Fig 1: Installing Procedure Fog Lamp - Rear
Courtesy of GENERAL MOTORS CORP.
- Turn off the lamp switch and allow the bulb to cool before changing the bulb.
- Leave the lamp switch OFF until the bulb change is complete.
- Always wear eye protection when changing a halogen bulb.
- Handle the bulb only by its base. Avoid touching the glass.
- Keep dirt and moisture off the bulb.
- Properly dispose of the used bulb.
- Keep halogen bulbs out of the reach of children.
Install the fog lamp retaining bolt (2).
Tighten

Tighten the bolt to 25 N.m (18 lb ft).
Connect the electrical connector to the fog lamp assembly.
Inspect the fog lamp aiming.