Auto Learn Method (Vue)

CAUTION: DO NOT use a BCM from another vehicle to aid in diagnosis. BCM's are not interchangeable after they have been installed.

NOTE: Passlock® learn procedure must be performed when Passlock® sensor, BCM or ECM are replaced. If only Passlock® sensor was replaced, auto learn method my be used. BCM or ECM replacement requires Saturn service stall method. Saturn service stall method require use of Tech 2 scan tool.

NOTE: If ignition is turned off before SECURITY indicator light changes state, relearn procedure must be restarted.

Check BCM and ECM for existing DTCs. If DTCs exist, repair as necessary and go to next step. If no DTCs exist, go to next step.
Turn ignition switch to RUN position. Momentarily turn ignition switch to START position. DO NOT start vehicle. Wait 10 minutes. When SECURITY indicator light changes from flashing to off, or from on to off, turn ignition switch to OFF position. Perform this process 3 times. After third time, vehicle should start on next ignition cycle.