FixVault
Home › Pontiac › 2002 › Aztek FWD › Repair and Diagnosis › External Pages › Different car › Section 1039 (Supplemental Inflatable Restraint System) › Repair Instructions › SIR Disabling and Enabling Zone 3 › Enabling Procedure

Enabling Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the key from the ignition.
  2. Connect the steering wheel module coil connector.
  3. Install the CPA from the inflatable restraint steering wheel module coil connector (1) located at the base of the steering column.
    4. Fig 1: Locating Inflatable Restraint Steering Wheel Module Coil Connector
    GM628317Courtesy of GENERAL MOTORS CORP.
  4. Install the LH insulator panel.
    5. Fig 2: Locating SIR Fuse
    GM628316Courtesy of GENERAL MOTORS CORP.
  5. Install the SIR Fuse.
  6. Install the console accessory wiring junction block access hole cover.
  7. Staying well away from all inflator modules and pretensioners, turn ON the ignition.
    1. The AIR BAG indicator will flash 7 times.
    2. The AIR BAG Indicator will then turn OFF.
  8. Perform Diagnostic System Check - SIR  if the AIR BAG indicator does not operate as described.
About FixVault