FixVault
Home › Pontiac › 2002 › Aztek FWD › Repair and Diagnosis › External Pages › Different car › Section 1248 (HVAC Systems - Automatic) › Repair Instructions › Sun Load Sensor Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: I/P Upper Trim Pad & Windshield Defroster Grille
    GM64706Courtesy of GENERAL MOTORS CORP.
  1. Release and lift the windshield defroster grille from the I/P upper trim pad.
    1. Insert two small flat bladed tools, close to each other between the rear edge of the defroster grille and the upper trim pad near one corner of the grille.
    2. Begin to CAREFULLY lift the grille up from the trim pad.
    3. Work the flat bladed tools gradually to the other corner of the grille while continuing to CAREFULLY pry the grille up.
  2. Lift the grille to access the sun load sensor, and/or DRL sensor, if equipped.
  3. Rotate to release the DRL sensor from the grille, if equipped.
    4. Fig 2: Disconnecting Sun Load Sensor Electrical Connector
    GM82164Courtesy of GENERAL MOTORS CORP.
  4. Rotate to release the sun load sensor from the grille.
  5. Disconnect the sun load sensor electrical connector.
  6. Remove the sun load sensor from the vehicle.
About FixVault