FixVault
Home › Pontiac › 2002 › Aztek FWD › Repair and Diagnosis › External Pages › Different car › Section 1493 (Antilock Brake System And TCS) › Repair Instructions › Brake Pressure Modulator Valve Bracket Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Transmission Control Module
    GM927845Courtesy of GENERAL MOTORS CORP.
  1. Remove the transmission control module (TCM), if equipped, from the mounting bracket and position aside.
    2. Fig 2: Disconnecting/Connecting Electrical Connector From Electronic Brake Control Module (EBCM)
    GM927847Courtesy of GENERAL MOTORS CORP.
  2. Turn the ignition switch to the OFF position.
  3. Disconnect the electronic brake control module (EBCM) electrical connector.
    4. Fig 3: Removing/Installing Brake Modulator Assembly To The Bracket
    GM927841Courtesy of GENERAL MOTORS CORP.
  4. Loosen the 2 insulator nuts on the brake pressure modulator valve (BPMV) assembly.
  5. Carefully lift the brake modulator assembly just enough to clear the bracket, then support the assembly.
    6. Fig 4: View Of BPMV Bracket
    GM890992Courtesy of GENERAL MOTORS CORP.
  6. Remove the brake pressure modulator assembly bracket mounting bolts.
  7. Remove the bracket from the vehicle.
About FixVault