FixVault
Home › Pontiac › 2003 › Aztek AWD › Repair and Diagnosis › External Pages › Different car › Section 255 (Supplemental Inflatable Restraint System) › Disabling & Activating Air Bag System › Disabling System › Zone 9

Zone 9

WARNING: This page is about a different car, the 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn steering wheel to place vehicle wheels in straight-ahead position. Turn ignition off and remove key. Remove SIR fuse (10-amp) from fuse block, located in junction block in center console. See Figure.
  2. If disabling passenger side impact air bag module only, go to step  6. If disabling other air bag system, complete all remaining steps.
  3. Remove driver-side insulator panel. Remove Connector Position Assurance (CPA) clip from driver-side air bag module connector. See Figure. Disconnect driver-side air bag module connector.
  4. Remove passenger-side insulator panel. Remove CPA clip from passenger-side air bag module connector. See Figure. Disconnect passenger-side air bag module connector.
  5. Remove CPA clip from driver side impact air bag module connector, located under driver seat. See Figure. Disconnect driver side impact air bag module connector.
  6. Remove Connector Position Assurance (CPA) clip from passenger side impact air bag module connector. See Figure. Disconnect passenger side impact air bag module connector.
About FixVault