FixVault
Home › Pontiac › 2003 › Aztek AWD › Repair and Diagnosis › External Pages › Different car › Section 449 (Lighting Systems) › Repair Instructions › Fog Lamp Aiming Procedure › Aiming Procedure

Aiming Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Alignment Points On Target Screen
    GM276650Courtesy of GENERAL MOTORS CORP.
  1. Park the vehicle 7.6 m (25 ft) away from the target screen.
  2. Measure from the center of the fog lamp to the ground line. Using this measurement, mark the horizontal centerline (2) of the fog lamp on the target screen directly in front of the vehicle.
  3. Turn ON the fog lamps. The top of the fog lamp beam image (4) on the target screen should be 102 mm (4 in) below the center of the fog lamp lens height.
    4. Fig 2: Identifying Fog Lamp Vertical Adjustment Nut
    GM814114Courtesy of GENERAL MOTORS CORP.
  4. Reach under the rear lower edge of the front fascia to access the fog lamp vertical adjustment nut (1).
  5. Adjust the fog lamp as required, using the adjusting nut (1) on the bottom of the fog lamp.
  6. Turn OFF the fog lamps.
About FixVault