FixVault
Home › Pontiac › 2003 › Aztek AWD › Repair and Diagnosis › External Pages › Different car › Section 467 (Body Rear End) › Repair Instructions › Trim Panel Replacement - Liftgate (Aztek) › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the upper liftgate trim panel to the liftgate by pressing down until fully seated.
    Fig 1: Identifying Upper Liftgate Trim Panel (Aztek)
    GM624443Courtesy of GENERAL MOTORS CORP.
  2. Position the defogger harness to the cutout in the upper trim panel.
  3. Install the right and the left side upper trim panel by pressing in until seated.
  4. Install the lower trim panels. Press down on the panels until fully seated.
    Fig 2: View Of Lower Liftgate Trim Panel (Aztek)
    GM624452Courtesy of GENERAL MOTORS CORP.
  5. Install the right and left sides of the lower trim panels, pressing in until fully seated.
  6. Close the liftgate.
About FixVault