FixVault
Home › Pontiac › 2003 › Aztek AWD › Repair and Diagnosis › External Pages › Different car › Section 480 (Wiper System & Washer System) › Repair Instructions › Wiper Motor Module Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the wiper arms. Refer to Wiper Arm Replacement .
  2. Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement in Body Front End.
  3. Remove the underhood electrical center. Refer to Underhood Electrical Center or Junction Block Replacement in Wiring Systems.
  4. Remove the cruise control module. Refer to Cruise Control Module Replacement in Cruise Control.
  5. Disconnect the wiper motor cover electrical connector.
  6. Remove the wiper system drive module bolts.
    Fig 1: View Of Wiper Motor Module
    GM697659Courtesy of GENERAL MOTORS CORP.
  7. Remove the wiper system drive module from the engine compartment.
About FixVault