FixVault
Home › Pontiac › 2003 › Aztek AWD › Repair and Diagnosis › External Pages › Different car › Section 659 (Seat System) › Repair Instructions › Seat Back Release Cable Replacement - Front › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Release Cables At Upper Seat Back Frame
    GM171524Courtesy of GENERAL MOTORS CORP.
  1. Insert the release cables through the opening in the upper seat back frame.
  2. Snap the release lever mechanism to the seat back frame.
  3. Route the cables.
    4. Fig 2: Actuators Underneath Seat Frame Springs
    GM71219Courtesy of GENERAL MOTORS CORP.
  4. Install the release cables to the right and left hinges inserting the locking pins in the notches.
  5. Apply Loctite™ 271 to the hinge bolts.
    6. NOTE: Refer to Fastener Notice in Cautions and Notices.
  6. Install the nuts to the right and left hinge bolts.

    Tighten:  Tighten the hinge bolt nuts to 24 N.m (18 lb ft).

  7. Install the seat back free play retention cable (passenger seat only).
    8. Fig 3: Seat Mounting Component View
    GM71215Courtesy of GENERAL MOTORS CORP.
  8. Install the seat back trim cover. Refer to Seat Back Cover and Pad Replacement - Front (RPO AR9 Base Seat) .
  9. Install the release lever bezel.
About FixVault