FixVault
Home › Pontiac › 2003 › Aztek AWD › Repair and Diagnosis › External Pages › Different car › Section 747 (Instrument Panel, Gages, And Console) › Repair Instructions › Console Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Console Screws
    GM987556Courtesy of GENERAL MOTORS CORP.
  1. Position the console on top of the center floor console.
    2. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the console screws.

    Tighten:  Tighten the screws to 2.5 N.m (22 lb in).

    3. Fig 2: View Of Auxiliary Power Outlet Electrical Connector
    GM1194731Courtesy of GENERAL MOTORS CORP.
  3. Connect the electrical connector to the auxiliary power outlet.
  4. Reposition the center console.
    5. Fig 3: Removing/Installing Cup Holder Liner
    GM1171184Courtesy of GENERAL MOTORS CORP.
  5. Install the cup holder screw.

    Tighten:  Tighten the screws to 2.5 N.m (22 lb in).

  6. Install the cup holder liner.
    7. Fig 4: Locating Console Screws
    GM1152195Courtesy of GENERAL MOTORS CORP.
  7. Reach under the front seats to access the lower console screws.
  8. Install the center console screws.

    Tighten:  Tighten the screws to 2.5 N.m (22 lb in).

  9. Position the front seat forward to the original position.
About FixVault