FixVault
Home › Pontiac › 2003 › Aztek AWD › Repair and Diagnosis › External Pages › Different car › Section 771 (Body Rear End) › Repair Instructions › Handle Replacement - Liftgate › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Lift Gate Handle
    GM928836Courtesy of GENERAL MOTORS CORP.
  1. Position the lift gate handle to the lift gate.
    2. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the bolts to the lift gate handle.

    Tighten:  Tighten the lift gate handle bolts to 4 N.m (35 lb in).

  3. Reconnect the outside handle swing over clip to the outside handle rod.
  4. Install the lock cylinder. Refer to Lock Cylinder Replacement - Liftgate  .
  5. Install the lift gate trim panel. Refer to Trim Panel Replacement - Liftgate  .
  6. Close the lift gate.
About FixVault