Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: The digital receiver bracket and the child tether attachment use the same fastener. Check the alignment of the child tether attachment and digital receiver bracket to the rear shelf prior to installing the fastener.

Install the receiver bracket (2) at a 45 degree angle to engage the locating tabs into the slots in the rear shelf (5).

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the child tether attachment bolt (3).
Tighten: Tighten the bolts to 28 N.m (21 lb ft).
Connect the electrical connector to the receiver (4).
Connect the coaxial cable lead to the receiver (4).

Fig 1: Installing Receiver
Courtesy of GENERAL MOTORS CORP.
Install the rear shelf trim panel. Refer to Trim Panel Replacement - Rear Window Shelf in Interior Trim.
Perform the setup procedure for the digital radio receiver. Refer to Digital Radio Receiver Setup .