FixVault
Home › Pontiac › 2003 › Sunfire Automatic › Repair and Diagnosis › External Pages › Different car › Section 198 (Supplemental Inflatable Restraint System) › Repair Instructions › Inflatable Restraint Side Impact Module Replacement - Front › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the inflator module (1) into the vehicle.
  2. Connect the electrical connector (2) to the inflator module (1).
    Fig 1: Locating Inflator Module Electrical Connector
    GM834212Courtesy of GENERAL MOTORS CORP.
  3. Install the CPA (3) to the inflator module electrical connector (2).
  4. Install the inflator module to the seat back frame (2).
    Fig 2: View Of Inflator Module
    GM834267Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the mounting nuts (1) to the inflator module.

    Tighten:  Tighten the nut to 9 N.m (80 lb in).

  6. Install the seat back cover. Refer to Seat Back Cover Replacement - Front (With AJ7) or Seat Back Cover Replacement - Front (Without AJ7) in Seats.
  7. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 7  or to SIR Disabling and Enabling Zone 9 .
About FixVault