FixVault
Home › Pontiac › 2003 › Sunfire Standard › Repair and Diagnosis › External Pages › Different car › Section 200 (Engine Controls - 2.2L (L61) Introduction) › Repair Instructions › Ignition Control Module Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Make sure the interconnect and seal are lined up before module installation.
  1. Install the ignition control module in the ignition coil housing.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the ICM retaining screws.

    Tighten:  Tighten the retaining screws to 1.5 N.m (13 lb in).

    Fig 1: View Of Ignition Control Module
    GM783965Courtesy of GENERAL MOTORS CORP.
  3. Connect the ICM harness connector.
  4. Install the accelerator cable bracket.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  5. Install the accelerator cable bracket bolt.

    Tighten:  Tighten the retaining screws to 10 N.m (18 lb in).

  6. Install the accelerator cable to the bracket.
About FixVault