FixVault
Home › Pontiac › 2003 › Sunfire Standard › Repair and Diagnosis › External Pages › Different car › Section 200 (Engine Controls - 2.2L (L61) Introduction) › Repair Instructions › Ignition Control Module Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn OFF the ignition.
  2. Remove the accelerator cable from the bracket.
  3. Remove the accelerator cable bracket bolt.
  4. Remove the accelerator cable bracket.
  5. Disconnect the ignition control module (ICM) harness connector.
    Fig 1: View Of Ignition Control Module
    GM783965Courtesy of GENERAL MOTORS CORP.
  6. Remove the ICM retaining screws.
  7. Remove the ICM from the ignition coil housing.
About FixVault