Bus Bar Lead Terminal Repair

Important: Do not overheat the terminal when resoldering.

Reattach the rear defogger bus bar lead terminals by soldering. Use a solder containing 3 percent silver and a rosin flux paste.
Before soldering the bus bar lead terminal, buff the repair area using fine steel wool.
Apply the paste-type rosin flux in small quantities to the bus bar lead terminal repair area using a brush.

NOTE: Use only enough heat to melt the solder. Using excessive heat can damage the rear window defogger components or the rear window.

Coat the soldering iron tip using solder prior to the repair procedure. Use only enough solder in order to ensure a complete repair.