FixVault
Home › Pontiac › 2004 › Aztek Base, AWD › Repair and Diagnosis › Brakes › Antilock Brake System And Traction Control System › Repair Instructions › Wheel Speed Sensor Jumper Harness Replacement - Front › Installation Procedure

Installation Procedure

    Fig 1: View Of Wheel Speed Sensor, Connector And Harness
    GM188809Courtesy of GENERAL MOTORS CORP.
  1. Connect the front wheel speed sensor jumper harness connector (2) to the wheel speed sensor.
    2. Fig 2: Identifying Front Wheel Speed Sensor Jumper Harness To ABS Harness Connector
    GM155156Courtesy of GENERAL MOTORS CORP.
  2. Install the harness (4) to control arm retaining clips (3).
  3. Install the harness (4) to splash shield retaining clip (5).
  4. Lower the vehicle.
  5. Connect the front wheel speed sensor jumper harness to ABS harness connector (8).
  6. Turn the ignition switch to the RUN position, with the engine off.
  7. Perform the diag system check. Refer to Diagnostic System Check - ABS .
About FixVault