FixVault
Home › Pontiac › 2004 › Aztek Base, AWD › Repair and Diagnosis › External Pages › Different car › Section 119 (Engine Control System - 4.2L (Introduction)) › Repair Instructions › Crankshaft Position (CKP) Sensor Replacement › Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
    2. Fig 1: Removing/Installing CKP Sensor
    GM1237427Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the crankshaft position (CKP) sensor harness connector.
  3. Remove the CKP sensor retaining bolt.
  4. Remove the CKP sensor from the engine block.
About FixVault