FixVault
Home › Pontiac › 2004 › Aztek Base, AWD › Repair and Diagnosis › External Pages › Different car › Section 121 (Supplemental Inflatable Restraint System) › Repair Instructions › SIR Disabling and Enabling Zone 8 › Enabling Procedure

Enabling Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the key from the ignition.
    2. Fig 1: Locating CPA & Steering Wheel Module Yellow 4-Way Connector
    GM869638Courtesy of GENERAL MOTORS CORP.
  2. Connect the steering wheel module yellow 4-way connector (2) located left of the steering column near the knee bolster.
  3. Install the CPA (1) to the steering wheel module yellow 4-way connector located left of the steering column near the knee bolster.
    4. Fig 2: Locating IP Module 4-Way Yellow Connector Behind IP Support
    GM869607Courtesy of GENERAL MOTORS CORP.
  4. Connect the I/P module yellow 4-way connector (1) located behind the I/P support.
  5. Install the CPA to the I/P module yellow 4-way connector (1) located behind the I/P support.
    6. Fig 3: Identifying CPA Clip
    GM869639Courtesy of GENERAL MOTORS CORP.
  6. Connect the RF side impact module yellow 2-way connector (1) located under the passenger seat.
  7. Install the CPA to the RF side impact module yellow 2-way connector (1) located under the passenger seat.
    8. Fig 4: Identifying CPA Clip
    GM869639Courtesy of GENERAL MOTORS CORP.
  8. Connect the LF side impact module yellow 2-way connector (1) located under the driver seat.
  9. Install the CPA to the LF side impact module yellow 2-way connector (1) located under the driver seat.
    10. Fig 5: View Of Fuse & Relay Block
    GM884366Courtesy of GENERAL MOTORS CORP.
  10. Install the SIR fuse to the fuse block (1) located in the underhood electrical center.
  11. Staying well away from all air bags, turn ON the ignition, with the engine OFF.
    1. The AIR BAG indicator will flash 7 times.
    2. The AIR BAG indicator will then turn OFF.
  12. Perform the Diagnostic System Check - SIR  if the AIR BAG indicator does not operate as described.
About FixVault