FixVault
Home › Pontiac › 2004 › Aztek Base, AWD › Repair and Diagnosis › External Pages › Different car › Section 126 (Body Rear End) › Repair Instructions › Handle Replacement - Liftgate › Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the license plate handle lever bracket into the slot in the license plate pocket.
    Fig 1: Installing License Plate Handle Lever Bracket
    GM1340031Courtesy of GENERAL MOTORS CORP.
  2. Install the liftgate handle into the license plate pocket.
  3. Install the liftgate handle spring to the liftgate handle.
    Fig 2: Installing Liftgate Handle Spring
    GM1340003Courtesy of GENERAL MOTORS CORP.
    4. Fig 3: Installing A New Liftgate Handle Pin
    GM1340026Courtesy of GENERAL MOTORS CORP.
  4. Install a new liftgate handle pin.
  5. Crimp the liftgate handle pin with long nose pliers.
  6. Install the license plate pocket. Refer to License Plate Pocket Replacement (Envoy XUV)  or License Plate Pocket Replacement (All Except Envoy XUV) .
About FixVault