FixVault
Home › Pontiac › 2004 › Aztek Base, AWD › Repair and Diagnosis › External Pages › Different car › Section 126 (Body Rear End) › Repair Instructions › Hinge Replacement - Liftgate › Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the body side hinges to the body.
    Fig 1: Installing Hinge-To-Body Retaining Nuts
    GM1344402Courtesy of GENERAL MOTORS CORP.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the nuts retaining the body side hinges to the body.

    Tighten:  Tighten the body side hinge nuts to 20 N.m (15 lb ft).

  3. Install the hinge pivots (1) to the body side hinges.
    Fig 2: Installing Body Side Hinge Pivots & Bushings
    GM1344406Courtesy of GENERAL MOTORS CORP.
  4. Install the hinge bushings (2) to the body side hinges.
  5. Install the hinge bushings (1) to the liftgate hinges.
    Fig 3: Installing Liftgate Hinge Bushings & Pivots
    GM1344405Courtesy of GENERAL MOTORS CORP.
  6. Install the hinge pivots (2) to the liftgate hinges.
  7. With the aid of an assistant, install the liftgate to the body side hinge by inserting the hinge pivots into the hinge bushings and sliding the liftgate to the right.
  8. Install the liftgate hinge pivot retainers (1) to the liftgate hinge pivots.
    Fig 4: Installing Liftgate Hinge Pivot Retainers
    GM1344407Courtesy of GENERAL MOTORS CORP.
  9. Connect the liftgate to the body wiring harness connector. Refer to Wiring Harness Replacement - Liftgate .
  10. Install the liftgate struts. Refer to Strut Replacement - Liftgate .
  11. Install the liftgate window. Refer to Window Replacement - Liftgate .
About FixVault