FixVault
Home › Pontiac › 2004 › Aztek Base, AWD › Repair and Diagnosis › External Pages › Different car › Section 126 (Body Rear End) › Repair Instructions › Liftgate Applique Replacement › Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Liftgate Applique
    GM721368Courtesy of GENERAL MOTORS CORP.
  1. Install the liftgate applique to the liftgate pinch-weld flange. Ensure that the liftgate applique is fully seated.
  2. Close the liftgate and open the liftgate window.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the screws that retain the liftgate applique to the body.

    Tighten:  Tighten the liftgate applique screws to 5 N.m (44 lb in).

  4. Close the liftgate window.
About FixVault