FixVault
Home › Pontiac › 2004 › Aztek Base, AWD › Repair and Diagnosis › External Pages › Different car › Section 126 (Body Rear End) › Repair Instructions › Midgate Panel Replacement - Outer › Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Midgate Outer Panel From Midgate
    GM1033832Courtesy of GENERAL MOTORS CORP.
  1. Install the midgate outer panel to the midgate assembly.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the nuts retaining the midgate outer panel to the midgate structure.

    Tighten:  Tighten the outer panel nuts to 5 N.m (44 lb in).

  3. Install the midgate sliding hinge filler panel. Refer to Hinge Filler Panel Replacement - Midgate Sliding .
  4. Install the midgate window run channels. Refer to Window Channel Replacement - Midgate .
  5. Install the midgate window regulator. Refer to Window Regulator Replacement - Midgate .
  6. Install the midgate window. Refer to Window Replacement - Midgate .
  7. Install the midgate window sealing strip. Refer to Sealing Strip Replacement - Midgate Window Outer .
  8. Install the midgate inner panel. Refer to Midgate Panel Replacement - Inner .
  9. Install the midgate assembly to the vehicle. Refer to Midgate Replacement .
About FixVault