FixVault
Home › Pontiac › 2004 › Aztek Base, AWD › Repair and Diagnosis › External Pages › Different car › Section 126 (Body Rear End) › Repair Instructions › Window Channel Replacement - Midgate › Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Midgate Window Run Channels
    GM1243189Courtesy of GENERAL MOTORS CORP.
  1. Install the midgate window run channels to the midgate.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Loosely install the screws retaining the midgate window run channels to the midgate.
  3. Install the wiring harness retainer to the window run channel bracket.
  4. Install the midgate window. Refer to Window Replacement - Midgate .
  5. Finish tightening the screws retaining the window run channels to the midgate.

    Tighten:  Tighten the screws to 10 N.m (89 lb in).

  6. Install the midgate inner panel. Refer to Midgate Panel Replacement - Inner .
About FixVault