FixVault
Home › Pontiac › 2004 › Aztek Base, AWD › Repair and Diagnosis › External Pages › Different car › Section 126 (Body Rear End) › Repair Instructions › Window Replacement - Liftgate › Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the liftgate window to the vehicle with the aid of an assistant.
    2. IMPORTANT: Do not open the liftgate once the hinge pins have been removed from the liftgate window.
    Fig 1: Installing Liftgate Window Hinge Pins & C-Clips
    GM696090Courtesy of GENERAL MOTORS CORP.
  2. With the liftgate closed align the liftgate windows hinge pin holes, install the hinge pins (1).
  3. Install the hinge pin C-clips (2) and (3) to the liftgate window hinge pins.
    4. Fig 2: Installing Liftgate Window Struts
    GM698590Courtesy of GENERAL MOTORS CORP.
  4. Open the liftgate window.

    With the aid of an assistant install the struts (3) to the liftgate window. Refer to Strut Replacement - Liftgate .

    5. Fig 3: View Of Liftgate Window Handle Bolts And Defogger Grid Electrical Connectors
    GM698542Courtesy of GENERAL MOTORS CORP.
  5. Install the outside handle (4) and striker to the liftgate window.
    6. NOTE: Refer to Fastener Notice in Cautions and Notices.
  6. Install the liftgate window handle bolts (3).

    Tighten:  Tighten the liftgate window handle bolts (3) to the striker plate to 5 N.m (44 lb in).

  7. Install the liftgate window defogger electrical connectors (2) to the right and left sides.
  8. Install the liftgate upper molding. Refer to Molding Replacement - Liftgate Upper in Exterior Trim.
  9. Inspect the operations of the liftgate window and center high mounted stop lamp (CHMSL).
  10. Close the liftgate window.
About FixVault