FixVault
Home › Pontiac › 2004 › Aztek Base, AWD › Repair and Diagnosis › External Pages › Different car › Section 142 (Frame & Underbody) › Repair Instructions › Engine Protection Shield Replacement › Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the engine shield.
    Fig 1: Removing/Installing Engine Shield
    GM687450Courtesy of GENERAL MOTORS CORP.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the engine shield mounting bolts.

    Tighten:  Tighten the engine shield mounting bolts to 25 N.m (18 lb ft).

  3. Lower the vehicle.
About FixVault