FixVault
Home › Pontiac › 2004 › Aztek Base, AWD › Repair and Diagnosis › External Pages › Different car › Section 188 (Lighting Systems) › Repair Instructions › High Mounted Stop Lamp Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the electrical connector to the high mounted stoplamp.
    2. Fig 1: High Mounted Stoplamp Electrical Connector
    GM458181Courtesy of GENERAL MOTORS CORP.
  2. Install the high mounted stoplamp pressing in until the retainers are fully seated.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the screws to the high mounted stoplamp.

    Tighten:  Tighten the high mounted stoplamp screws to 2 N.m (18 lb in).

    4. Fig 2: High Mounted Stoplamp
    GM458174Courtesy of GENERAL MOTORS CORP.
  4. Install the high mounted stoplamp bracket.
  5. Install the screw to the high mounted stoplamp bracket.

    Tighten:  Tighten the high mounted stoplamp bracket screw to 2 N.m (18 lb in).

    6. Fig 3: High Mounted Stoplamp Bracket
    GM669080Courtesy of GENERAL MOTORS CORP.
  6. Close the rear compartment.
About FixVault