FixVault
Home › Pontiac › 2004 › Aztek Base, AWD › Repair and Diagnosis › External Pages › Different car › Section 188 (Lighting Systems) › Repair Instructions › Roof Side Rail Lamp Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the bulb if necessary.
    2. Fig 1: Installing Rail Lamp Bulb
    GM678342Courtesy of GENERAL MOTORS CORP.
  2. Install the side rail lamp socket to the base plate by sliding on.
  3. Connect the electrical connector to the side rail lamp.
  4. Install the service loop to glue using foam tape.
  5. Align the side rail lamp base plate to the plastic retainers.
    6. Fig 2: Side Rail Lamp
    GM678343Courtesy of GENERAL MOTORS CORP.
    Fig 3: Aligning Side Rail Lamp
    GM678339Courtesy of GENERAL MOTORS CORP.
  6. Position the side rail lamp assist handle to the base plate and the plastic retainers.
    7. Fig 4: Installing Assist Handle
    GM678338Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 5: Installing Assist Handle Screws
    GM678337Courtesy of GENERAL MOTORS CORP.
  7. Install the screws to the side rail lamp assist handle.

    Tighten:  Tighten the side rail lamp assist handle screws to 2 N.m (18 lb in).

  8. Close the assist handle covers pressing into place until fully seated.
About FixVault