Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.

Install the MAP sensor.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the MAP sensor screws.
Tighten: Tighten the screws to 5 N.m (44 lb in).
Connect the MAP sensor electrical connector and the vacuum hose.
Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement in Engine Mechanical 3.8L.

Fig 1: Installing MAP Sensor (L67)

Courtesy of GENERAL MOTORS CORP.