Rear Toe Adjustment

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.

Loosen the hex nuts at the rear wheel spindle rod - rear.

Fig 1: Adjusting Hex Nuts For Rear Toe Adjustment
Courtesy of GENERAL MOTORS CORP.
Turn the adjusting nut to change the toe angle.
Adjust the toe to the proper setting. Refer to Wheel Alignment Specifications (Front) or Wheel Alignment Specifications (Rear) .

Fig 2: Changing Rear Toe Angle

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Tighten the hex nuts on the rear wheel spindle rod - rear.
Tighten: Tighten the rear wheel spindle rod ends hex nuts to 50 N.m (37 lb ft).

Fig 3: Tightening The Hex Nuts On The Rear Wheel Spindle Rod

Courtesy of GENERAL MOTORS CORP.