Zone 3

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Turn steering wheel to place vehicle wheels in straight-ahead position. Turn ignition off and remove key.
Remove right front floor kick-up panel. Remove SDM fuse (15-amp) located in instrument panel fuse block, located in right front footwell. Remove driver-side knee bolster. Remove Connector Position Assurance (CPA) clip and disconnect driver-side air bag module Yellow 2-pin connector, located at base of steering column. See Fig 1.

Fig 1: Locating Driver-side Air Bag Yellow 2-pin Connector

Courtesy of GENERAL MOTORS CORP.