FixVault
Home › Pontiac › 2004 › Aztek Base, AWD › Repair and Diagnosis › External Pages › Different car › Section 25 (Supplemental Inflatable Restraint System) › Disabling & Activating Air Bag System › Disabling System › Zone 4

Zone 4

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn steering wheel to place vehicle wheels in straight-ahead position. Turn ignition off and remove key.
  2. Remove right front floor kick-up panel. Remove SDM fuse (15-amp) located in instrument panel fuse block, located in right front footwell. Remove driver-side knee bolster. Remove Connector Position Assurance (CPA) clip and disconnect driver-side air bag module Yellow 2-pin connector, located at base of steering column. See Figure. Remove CPA clip and disconnect passenger-side air bag module Yellow 2-pin connector, located on right side of steering column. See Fig 1.
Fig 1: Locating Passenger-side Air Bag Yellow 2-pin Connector
G98F13552Courtesy of GENERAL MOTORS CORP.
About FixVault