FixVault
Home › Pontiac › 2004 › Aztek Base, AWD › Repair and Diagnosis › External Pages › Different car › Section 261 (Lighting Systems) › Repair Instructions › Fog Lamp Replacement - Front › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the electrical connector to the fog lamp bulb/socket.
    2. Fig 1: Electrical Connector & Fog Lamp Bulb/Socket
    GM812125Courtesy of GENERAL MOTORS CORP.
  2. Install the fog lamp bulb/socket to the fog lamp, turning clockwise, if required.
    3. Fig 2: Fog Lamp & Front Bumper Fascia
    GM1228603Courtesy of GENERAL MOTORS CORP.
  3. Position the fog lamp to the front bumper fascia.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the front fog lamp screws to the fog lamp.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

    5. Fig 3: Front Fog Lamp Screws
    GM1228602Courtesy of GENERAL MOTORS CORP.
  5. Check and adjust the front fog lamp aim as necessary. Refer to Fog Lamp Aiming Procedure .
About FixVault