FixVault
Home › Pontiac › 2004 › Aztek Base, AWD › Repair and Diagnosis › External Pages › Different car › Section 276 (Steering Wheel And Steering Column) › Repair Instructions › Multifunction, Turn Signal Switch Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Turn Signal Switch Assembly
    GM761439Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The electrical contact on the turn signal and multifunction switch assembly must rest on the turn signal cancel cam assembly.
  1. Install the turn signal and multifunction switch assembly.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Secure by using 2 pan head tapping screws.

    Tighten

    • Tighten the screw on the top of the column to 3 N.m (27 lb in).
    • Tighten the screw in the front to 7 N.m (62 lb in).
  3. Connect the connectors to the turn signal and multifunction switch assembly.
  4. Install the upper and lower trim covers. Refer to Steering Column Trim Covers Replacement .
  5. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
About FixVault