Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Multifunction Turn Signal Switch Assembly

GM323838

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: The electrical contact must rest on the turn signal cancel cam assembly.

Install the multifunction turn signal switch assembly (1) to the steering column assembly.

Fig 2: 2 Pan Head Tapping Screws

GM323837

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the 2 pan head tapping screws (1).
Tighten: Tighten the screws to 7 N.m (62 lb in).

Fig 3: Wire Harness Assembly & Steering Column Jacket Assembly

GM323839

Courtesy of GENERAL MOTORS CORP.

Route the wire harness assembly along the steering column jacket assembly.

Fig 4: Wire Harness Assembly & Wire Harness Strap

GM323836

Courtesy of GENERAL MOTORS CORP.

Install the wire harness assembly (1) into the wire harness strap (2).

Fig 5: Wire Harness Straps & Steering Column Tilt Head Assembly

GM323835

Courtesy of GENERAL MOTORS CORP.

Install new wire harness straps (2) to the steering column assembly (1) and the column.

Fig 6: View Of Lower And Upper Steering Column Covers

GM328807

Courtesy of GENERAL MOTORS CORP.

Install the upper and lower steering column trim covers. Refer to Steering Column Trim Covers Replacement (Telescoping) or Steering Column Trim Covers Replacement (Manual) .