FixVault
Home › Pontiac › 2004 › Aztek Base, AWD › Repair and Diagnosis › External Pages › Different car › Section 331 (Lighting Systems) › Repair Instructions › Fog Lamp Replacement - Front › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Brake Caliper Cooling Duct To Front Fascia
    GM171878Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the front fascia lower close out panel. Refer to Close Out Panel - Front Bumper Fascia Lower in Bumpers.
  3. Release the brake caliper cooling duct from the front fascia and position the duct aside.
    4. Fig 2: Front Fog Lamp Electrical Connector To Fog Lamp Bulb/Socket
    GM64629Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the front fog lamp electrical connector from the fog lamp bulb/socket.
    5. Fig 3: Front Fog Lamp To Front Bumper Impact Bar
    GM64632Courtesy of GENERAL MOTORS CORP.
  5. Remove the front fog lamp mounting bolt from the front bumper impact bar.
  6. Remove the fog lamp from the vehicle.
About FixVault