FixVault
Home › Pontiac › 2004 › Aztek Base, AWD › Repair and Diagnosis › External Pages › Different car › Section 331 (Lighting Systems) › Repair Instructions › Headlamp Motor/Actuator Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Headlamp Wiring Harness Electrical Connectors To Headlamp Bulb/Sockets
    GM64691Courtesy of GENERAL MOTORS CORP.
  1. Position the headlamp motor/actuator to the headlamp assembly.
  2. Install the pivot arm to the motor.

    Place the pivot arm in the position noted prior to removal.

  3. Loosely install the nut retaining the headlamp assembly pivot arm to the motor/actuator.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the headlamp motor/actuator bolts.

    Tighten: 

    • Tighten the headlamp motor/actuator mounting bolts to 7 N.m (62 lb in).
    • Tighten the headlamp motor/actuator to pivot arm nut to 6 N.m (53 lb in).

  5. Connect the headlamp wiring harness electrical connectors to the headlamp bulbs.
  6. Install the headlamp assembly to the vehicle. Refer to Headlamp Replacement .
About FixVault