FixVault
Home › Pontiac › 2004 › Aztek Base, AWD › Repair and Diagnosis › External Pages › Different car › Section 331 (Lighting Systems) › Repair Instructions › Park/Turn Signal/Side Marker Lamp Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Brake Caliper Cooling Duct To Front Fascia
    GM171878Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the front fascia lower closeout panel. Refer to Close Out Panel - Front Bumper Fascia Lower in Bumpers.
  3. Release the brake caliper cooling duct from the front fascia, and position the duct aside.
    4. Fig 2: Lamp Bracket To Front Fascia
    GM64639Courtesy of GENERAL MOTORS CORP.
  4. Remove the front turn signal lamp bracket retaining spring from the lamp bracket.
  5. Remove the lamp bracket retaining spring from the front fascia.
  6. Remove the front turn signal lamp bracket retaining screws.
    7. Fig 3: Sockets To Lamp
    GM64634Courtesy of GENERAL MOTORS CORP.
  7. Disconnect the sockets from the lamp.
    8. Fig 4: Lamp To Bracket & Screws
    GM64641Courtesy of GENERAL MOTORS CORP.
  8. Remove the lamp, with the bracket, from the vehicle.
  9. Remove the lamp to bracket retaining screws.
  10. Remove the lamp from the bracket.
About FixVault