Section 60 (Steering Wheel And Steering Column): Specifications
WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
Fastener Tightening Specifications
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Intermediate Shaft to the Steering Gear Pinch Bolt | 34 N.m | 25 lb ft |
| Steering Column Trim Cover Screws Lower | 4 N.m | 35 lb in |
| Column Support Bracket Nuts Upper (Tighten in Sequence) | 24 N.m | 17 lb ft |
| Column Support Bracket Nuts Lower (Tighten in Sequence) | 24 N.m | 17 lb ft |
| Lower Steering Coupling Shield Screw | 3.5 N.m | 31 lb in |
| Multifunction Switch Screws | 7 N.m | 62 lb in |
| Steering Column Support Screws | 17 N.m | 13 lb ft |
| Steering Wheel Set Nut | 41 N.m | 30 lb ft |
| Intermediate Shaft to the Steering Column Pinch Bolt | 48 N.m | 35 lb ft |
| Steering Column Trim Cover Screws Upper | 1.4 N.m | 12 lb in |
| Actuator Retaining Screws | 9 N.m | 80 lb in |
| Telescope Drive Bolt | 7 N.m | 62 lb in |
| Telescope Drive Bracket Screw | 7 N.m | 62 lb in |