FixVault
Home › Pontiac › 2004 › Aztek Base, AWD › Repair and Diagnosis › External Pages › Different car › Section 99 (Seat System) › Repair Instructions › Seat Cushion Frame Replacement - Front › Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the wiring harness and connector clips, if you replaced the frame.
  2. Install the seat memory module, if equipped. Refer to Memory Seat Control Module Replacement .
    3. Fig 1: View Of Underside Of Seat Adjuster Frame & Mounting Nuts
    GM752864Courtesy of GENERAL MOTORS CORP.
  3. Install the seat cushion cover and pad to the seat frame. Refer to Seat Cushion Cover and Pad Replacement - Front .
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the 4 nuts that secure the seat pan to the power seat adjuster frame.

    Tighten:  Tighten the seat pan mounting nuts to 25 N.m (18 lb ft).

    5. Fig 2: Identifying Connectors & Harness
    GM752865Courtesy of GENERAL MOTORS CORP.
  5. Install the seat harness to the seat pan.
  6. Install the SIR harness (2) to the seat clips (1, 4).
  7. Connect the gray lumbar electrical connector (5), if equipped.
  8. Connect the black electrical connector (3) to the seat belt buckle.
  9. Connect the black electrical connector (6) to the seat back harness.
  10. Install the 3 seat switch bezel mounting screws. Refer to Seat Switch Bezel Replacement .
About FixVault