FixVault
Home › Pontiac › 2004 › Aztek Base, FWD › Repair and Diagnosis › External Pages › Different car › Section 120 (Engine Control System - 4.8L, 5.3L, & 6.0L - Introduction) › Repair Instructions › Air Cleaner Element Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 Chevrolet TrailBlazer, and 2004 Buick Rainier. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Air Cleaner Assembly
    GM1217755Courtesy of GENERAL MOTORS CORP.
  1. Install the MAF/IAT sensor (3) to the air filter element (6).
  2. Install the air filter element (6) and MAF/IAT sensor (3) to the lower air cleaner housing/washer solvent tank assembly (4).
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
    IMPORTANT: Ensure the air inlet duct (5) is properly positioned in the lower air cleaner housing/washer solvent tank assembly (4) before installing the air cleaner cover (2).
  3. Install the air cleaner cover (2).

    Tighten:  Tighten the 4 air cleaner cover retaining screws (1) to 4 N.m (35 lb in).

  4. Install the radiator support diagonal brace. Refer to Brace Replacement - Radiator Support Diagonal in Body Front End.
    5. Fig 2: View Of MAF/IAT Sensor Electrical Connector
    GM1204792Courtesy of GENERAL MOTORS CORP.
  5. Connect the MAF/IAT sensor electrical connector (1).
  6. Install the air cleaner outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement .
About FixVault