FixVault
Home › Pontiac › 2004 › Aztek Base, FWD › Repair and Diagnosis › External Pages › Different car › Section 258 (Wiring Systems) › Repair Instructions › Junction Block Replacement - Accessory Wiring › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Seat the bottom junction block tabs and snap the top of the junction block to the passenger knee bolster.
    2. Fig 1: Junction Block Tabs & Passenger Knee Bolster
    GM929411Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the junction block bolt.

    Tighten:  Tighten the junction block bolt to 10 N.m (89 lb in).

    3. Fig 2: Body Wiring Harness & Accessory Wiring Junction Block Bolt
    GM928964Courtesy of GENERAL MOTORS CORP.
  3. Close the I/P compartment.
  4. Connect the body wiring harnesses to the junction block.

    Tighten:  Tighten the connector bolt to 2.5 N.m (22 lb in).

  5. Install the I/P compartment access hole cover.
    6. Fig 3: I/P Compartment Access Hole Cover
    GM1203017Courtesy of GENERAL MOTORS CORP.
  6. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
About FixVault