FixVault
Home › Pontiac › 2004 › Aztek Base, FWD › Repair and Diagnosis › Suspension › Electronic Suspension › Suspension Control System - Suspension Leveling › Repair Instructions › Inflator Solenoid Replacement › Installation Procedure

Installation Procedure

    Fig 1: View Of Inflator Solenoid
    GM865401Courtesy of GENERAL MOTORS CORP.
  1. Install the inflator solenoid to the air compressor assembly bracket.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the screws (3) into the inflator solenoid and the air compressor bracket.

    Tighten:  Tighten the screws to 6 N.m (53 lb in).

  3. Install the electrical connector (2) onto the inflator solenoid.
  4. Install the hoses (1) onto the inflator solenoid.
  5. Lower the vehicle.
About FixVault