FixVault
Home › Pontiac › 2004 › GTO Automatic › Repair and Diagnosis › Restraints › Air Bag, SRS › Supplemental Inflatable Restraint System › Repair Instructions › Inflatable Restraint Sensing and Diagnostic Module Replacement › Installation Procedure

Installation Procedure

    Fig 1: View Of SDM Assembly
    GM1343048Courtesy of GENERAL MOTORS CORP.
  1. Install the SDM assembly (1) into the vehicle. Ensure arrow on SDM label is pointing towards the front of the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
    IMPORTANT: Ensure the wiring harness ground lead (3) is installed under the left rear SDM (1) retaining bolt.
  2. Install the three SDM fasteners (2).

    Tighten:  Tighten the fasteners to 9 N.m (80 lb in).

  3. Install the SDM electrical connector.
  4. Install the center console. Refer to Console Replacement - Front Floor in Instrument Panel, Gages and Console.
  5. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 8 .
About FixVault